2.Installation
26
When [Set Up Later] on the administrator password setting screen in step 5 is selected, forcibly display
the administrator password setting screen by the following procedure.
1. After the machine installation, enter the SP mode and execute the SP5-755-001 (Display
Setting: Disp Administrator Password Change Scrn).
2. Power cycle the machine. The following Program/Change Administrator screen is displayed.
3. Ask your customer to set the supervisor and administrator password.
If the Administrator/Supervisor Login password set, this Program/Change Administrator screen
will disappear and the home screen is displayed.
If a password is not necessary, this screen can be disabled with the following procedure.
1. On the Program/Change Administrator screen, press [Change] next to Supervisor and then
press [OK] without inputting any password.
2. Press [OK] again when the Confirm password screen is displayed.
3. For Administrator 1, do the same procedure as steps 1 and 2.
4. Press [OK]. The home screen is displayed.
Important Notice on Security Issues (IM 550F/IM 600F/IM 600SRF Only)
In order to increase the security of the MFP, and to ensure that the customer sets the administrator
password, an administrator set/change prompt display appears at the first power-up.
To Next Page
Loading...
