• Like the previous model, the animation is updated by inserting the SD card into the SD card
slot (bottom) at the back of the main unit.
Firmware Update (Removable Media)
Overview
• Removable media (such as SD cards or USB flash drives) are precision devices, so when you
handle them, respect the following.
• When the power is switched ON, do not insert or remove the removable media.
• During installations, do not switch the power OFF.
• Since the removable media is manufactured with high precision, do not store it in a hot or
humid location, or in direct sunlight.
• Do not bend the removable media, scratch it, or give it a strong shock.
• Before downloading firmware to an SD card, check whether write-protection of the SD card is
removed. If write-protection is locked, an error code (error code 44, etc.) will be displayed
during download, and the download will fail.
• Before updating the firmware, disconnect network cables and interface cables, remove
wireless boards, etc., (so that they are not accessed during the update).
Using the SD card for Updating
Use SD Card Slot 2 [E: Lower Slot] on the back of the machine or the SD card slot [F] on the left side of
the operation panel.
• When inserting into the slot, push the SD card until it clicks.
• Check whether the card is properly in the SD card slot. When an SD card is inserted, a click is
heard, and it is locked.
• To remove the card, release it by pushing it once.
To Next Page
Loading...
