Ricoh IM 550F

8.Smart Operation Panel G2.5
742
• LCD on the operation panel: ON.
• HDD cannot be accessed for 60 sec.
• If the backup data has not changed, no backup will be performed. (Maximum - 7 days)
• During the backup, the LCD is off.
• Backup data is stored on the HDD.
• The amount of time for the backup is as follows:
Example:
Data
Backup time
Additional applications
106MB
1m 6s
Application settings
0.2MB
36s
Total
106.2MB
1m 42s
Disabling the Backup setting
The default setting is “Enabled”. To change it to “Disabled”, uncheck “Enabled”. Restarting the machine
is not necessary.
In Cheetah SP mode, select [Screen Device Settings] > [Backup/Restore Settings] In Cheetah SP
mode.
Restore
• If the machine doesn’t have any backup data, the restore function cannot be used.
1. Execute [Cheetah SP mode] > [Screen Device Settings] > [Backup/Restore Settings] > [Start
Restore].
2. After a message indicating that restoration takes several minutes is displayed, touch "execute".
A message saying please wait for a while is displayed. Time is about 10 minutes.
3. After a message indicating that the next message is displayed, touch [Close].
A message that the restoration was successful is displayed.
4. Turn the main switch off/on.
Restore Error Codes
If the restore fails and an error code appears on the operation panel.
Code
Cause
Solution
1
Failed to restore additionally installed application data
Retry the Restore procedure.
3
Failed to restore application setting data
Retry the Restore procedure.