Error Name/Error Condition/Major Cause/Solution
• The writing data and reading data do not match 8 times consecutively.
EEPROM on the controller board (PCB15) defective
1. Turn the main power OFF and wait for 5 seconds. Then turn ON the main
power.
2. Check whether the EEPROM on the controller board (PCB15) is installed
correctly. If necessary, reinstall it.
3. Replace the controller board (PCB15).
4. If the EEPROM on the controller board (PCB15) is damaged, replace the
EEPROM.
Error Name/Error Condition/Major Cause/Solution
EEPROM Communication Error 1
Controller board (PCB15) defective
Replace the controller board (PCB15).
Error Name/Error Condition/Major Cause/Solution
Reading data from EEPROM is abnormal.
EEPROM on the controller board (PCB15) defective
1. Turn the main power OFF and wait for 5 seconds. Then turn the main power
ON.
2. Replace the IOB (PCB17).
3. If the EEPROM on the controller board (PCB15) is damaged, replace the
EEPROM.
Error Name/Error Condition/Major Cause/Solution
Paper jam (J010, J011, J012, J013, J014, J015) is detected twice.
Controller board (PCB15) defective
Replace the controller board (PCB15).
Error Name/Error Condition/Major Cause/Solution
Engine does not startup during the starting up