This icon is displayed when there is temporary data to be overwritten, and
flashes during overwriting.
Data Overwrite Security (P 800/801)
Before You Begin the Procedure
1. Make sure that the following settings (1) to (3) are not at their factory default values.
(1) Supervisor login password
(2) Administrator login name
(3) Administrator login password
If any of these settings are at their factory default values, tell the customer that these settings must
be changed before you do the installation procedure.
2. Make sure that "Administrator Authentication Management" is on.
1. Log in as the administrator from Web Image Monitor.
2. [Device Management] -> [Configuration] -> [Device Settings] -> [Administrator Authentication
Management]
3. From [User Administrator Authentication], [Machine Administrator Authentication], [Network
Administrator Authentication], and [File Administrator Authentication], set the administrator
authentication setting to [On].
If this setting is off, tell the customer that this setting must be on before you do the installation
procedure.
Using Auto Erase Memory
The Auto Erase Memory function can be enabled by the following procedure.
To Next Page
Loading...
