Ricoh IM 550F

4.Replacement and Adjustment
225
Image Adjustment
Printing
• Make sure the paper is set correctly in each paper tray before you start these adjustments.
• Use Trimming Area Pattern (SP2-109-003, No.14) to print the test pattern for the following
procedures.
• Set SP2-109-003 to "0" again after completing these printing adjustments.
Registration: Leading Edge/Side-to-Side
A: Leading Edge Registration (4 ± 2.5 mm)
B: Side-to-side Registration (4 ± 2.5 mm)
1. Check the leading edge registration [A] for each paper feed station, and adjust them using SP1-
001.
Paper Feed Station
SP No.
Adjustment Range
Tray 1 (Main unit)
SP1-001-001
4±2.5 mm
Tray 2 (Optional tray)
SP1-001-002
Tray 3 (Optional tray)
SP1-001-003
Tray 4 (Optional tray)
SP1-001-004
Tray 5 (Optional tray)
SP1-001-005
Bypass Tray
SP1-001-006
Duplex Tray
SP1-001-007
2. Check the side-to-side registration [B] for each paper feed station, and adjust them using SP1-002.
Paper Feed Station
SP No.
Adjustment Range
Tray 1 (Main unit)
SP1-002-001
4±2.5 mm
Tray 2 (Optional tray)
SP1-002-002
Tray 3 (Optional tray)
SP1-002-003
Tray 4 (Optional tray)
SP1-002-004