Installation and Updating of applications and
firmware update can be done from the Application
Site. When administrator authentication is enabled,
an administrator privilege is required to start the
Application Site. If you log in to the operation panel
service mode, however, you can use it with CE
privilege.
*1 Update can only be done by using a package file.
The following two methods can be used for updating the firmware.
• Update from a media
• Installation/update from Application Site
The following three methods can be used for updating an application.
• Installation/update from a media
• Installation/update from the eDC Server
• Installation/update from Application Site
Installation/Update from a Media
Installing/Updating an Application
Creating a media card for update
1. Download the update modules from the Firmware Download Center.
2. Create a folder named “romdata” in the root directory of the media.
3. Put the zip file of the application in the “romdata” folder.
Do not unzip the zip file.
Update procedure
1. Log in to the control panel in service mode.
2. Insert the SD card into the SD card slot of the control panel.
3. Select [Apps] > [Install] > [Install from SD Card].
4. Select the application you want to install or update, and then press [Install]
5. The installation or update results are displayed.
6. Check that the application is correctly installed or updated, and then press [reboot operation panel].
Package Update
This method uses the package update function to update the control panel firmware and/or
To Next Page
Loading...
