8.Smart Operation Panel G2.5
701
5. Remove the LCD unit [A].
6. Remove the LCD [A].
• After replacing the LCD, perform the following checks.
• LCD Check (LCD Check)
• TouchPanel Check (TouchPanel Check)
• Perform "TouchPanel Calibration" (TouchPanel Calibration) and "MultiTouch Calibration"
(MultiTouch Calibration) of the Self Check function.
Microphone
1. Remove the operation panel unit. (Refer to "Operation Panel (PCB13)", "Replacement and
Adjustment" in Main Chapters.)
2. Remove the main controller board (Main Controller Board).
To Next Page
Loading...
