Installation Procedure
For instructions on unpacking and installing Paper Feed Unit PB1160, please refer to the operating
instructions "Setup".
When installing with the caster table
Installation by service representative may be required when installing Paper Feed Unit PB1160 with
Caster Table Type M40, depending on the machine configuration.
*1 The attaching stands and connecting parts need to be installed to prevent the machine from falling
over. If it falls or topples over, an injury might occur. For instructions on installing Paper Feed Unit
PB1160 and Caster Table Type M40, please refer to the procedure described in this section.
Installing the optional paper feed unit on the caster table
• Turn OFF the main power, and unplug the machine power cord before starting the following