4.Replacement and Adjustment
281
Exterior Covers (P 800/801)
Upper Cover
1. Remove the controller cover. (Controller Cover)
2. Open the upper cover [A].
3. Remove the two screws from the upper cover [A].
• The screw [B] is a sems screw. The screw [C] is a tapping screw. Be careful not to use the
wrong screws when installing the upper cover.
4. Remove the screw from the rear side of the upper cover [A].
5. Lift the upper cover [A] by releasing the two hooks, and then put it on the mainframe so that you
To Next Page
Loading...
