4.Replacement and Adjustment
451
2. Remove the finisher main board cover.
3. Remove the finisher main board (PCB29).
When reinstalling a new finisher main board
Check the DIP switches (SW1: [A], SW2: [B]) on the old main board. If the settings on the new finisher
main board are different from the old finisher main board, change the settings on the new board (they
must be the same as the settings on the old board).
Finisher Side-to-Side Registration Adjustment
When the stapled prints are not aligned adequately, it may be because the finisher side-to-side
To Next Page
Loading...
