8.Smart Operation Panel G2.5
705
• By factory default, the following switches of the DIP switch [A] on the main controller board are
set to ON: No.1, No.3, and No.6. When installing the operation panel unit, make sure that the
DIP switch setting is correct for the MFP on which you are installing the panel.
• The correct DIP switch setting depends on the MFP. Note the DIP switch settings of the old
operation panel unit before replacing, and apply the same settings to the new Smart Operation
Panel.
The following example is for DIP switch settings when the following switches are set to ON:
No.1, No.3, and No.6 (this is the factory default setting of a service part).
• If the DIP switch setting is wrong, SC672 will be displayed.
• DIP switch No.1 turns ON/OFF the SC reduction function. Change the setting when needed.
• 0 (OFF): The SC is displayed on the operation panel when SC672/SC673 occur.
• 1 (ON): If the error is caused by a software defect when SC672/SC673
To Next Page
Loading...
