3.SP Mode Tables (Common for both MF Model and Printer Model)
37
when jobs exceeding the number guaranteed by the job
monitor are continuously printed.)
Timing of the PJL Status ReadBack (JOB END) when
printing multiple collated copies.
This BitSw determines the timing of the PJL STATUS
JOB END sent when multiple collated copies are being
printed. Mode 0: JOB END is sent by the device to the
client after the first copy has completed printing. This
causes the page counter to be incremented after the
first copy and then again at the end of the job. Mode 1:
JOB END is sent by the device to the client after the last
copy has finished printing. This causes the page counter
to be incremented at the end of each job.
Enabled (=0): Text composed of UTF-8 characters can
be displayed in the operation panel. Disabled (=1): UTF-
8 characters cannot be displayed in the operation panel.
For example, job names are sometimes stored in the
MIB using UTF-8 encoded characters. When these are
displayed on the operation panel, they will be garbled
unless this BitSw is enabled (=0).
Print Option Configuration (rsh, rcp, ftp)
This BitSw enables the specification of the configuration
of the print option using rcp/rsh/ftp.
Enable/Disable Print from USB/SD's Preview
function
Determines whether the Print from USB/SD function will
have the Preview function. Enabled (=0): Print from
USB/SD will have the Preview function. Disabled (=1):
Print from USB/SD will not have the Preview function.
(IM 550F/600F/600SRF only)
To Next Page
Loading...
