2.Installation
87
21. Install the FG clamp [A] to the operation panel arm.
• When installing the FG clamp, bind the USB cable [B] with the FG clamp [A]. Make sure to
bind the part where the coating is stripped partially.
• When installing the FG clamp [A], use the screw provided with NFC Card Reader Type
M24.
22. Attach the hook and loop fastener [A] to the base cover [B] at the position shown below.
23. Peel off the mount from the hook and loop fastener, and then attach the NFC card reader [A] to the
To Next Page
Loading...
