SATO CL6NX - Page 443

441
Parameters for Block Lock (omissible)
parameter error will occur if not specified in pairs. This option can only be used with the standard format. A
parameter error will occur if used with the conventional format.
E.g.:
<RK>2,D40,00000000AAAAAAAA44444444BBBBBBBB88888888,lbs:0,lbn:2,lbs:4,lbn:2,lbs:8,lbn:2
Parameters related to option flag data control (omissible)
eas:
(former Ea:)
EAS bit operation Writes value to EAS (Electronic Article Surveillance)
bit.
Valid range: 0-1
afi:
(former Af:)
AFI operation Writes value to AFI (Application Family Identifier).
Inlets that do not support AFI cannot be operated.
Valid range: 00-FF (HEX)
dsf:
(former Ds:)
DSFID operation Writes value to DSFID (Data Storage Format
Identifier).
Inlets that do not support DSFID cannot be operated.
Valid range: 00-FF (HEX)
Parameters related to perma-lock (omissible)
eal: Perma-lock for EAS flag Locks EAS flag cannot be unlocked after perma-lock.
Perma-lock is implemented when 1 is specified.
Nothing is implemented when 0.
Valid range: 0-1
afl:
(former Al:)
Perma-lock for AFI code Locks AFI code cannot be unlocked after perma-lock.
Perma-lock is implemented when 1 is specified.
Nothing is implemented when 0.
Valid range: 0-1
dsl:
(former Dl:)
Perma-lock for DSFID code Locks DSFID code cannot be unlocked after perma-
lock.
Perma-lock is implemented when 1 is specified.
Nothing is implemented when 0.
Valid range: 0-1
Parameters related to password lock (omissible)
eap: EAS password lock Locks EAS flag with specified password.
Valid range: 00000000-FFFFFFFF, 8-digit
hexadecimal
Parameters related to ID write (omissible)
eai: EAS ID write. Writes EAS ID with specified ID.
Valid range: 0000-FFFF, 4-digit hexadecimal
Parameters related to various password settings for ICODE (omissible)
pw0: Read/Write protect user memory Sets password for read/write protection.
Valid range: 00000000-FFFFFFFF, 8-digit
hexadecimal
pw1: Write-protect user memory Sets password for write protection.