Technology instructions
10.3 Motion control
S7-1200 Programmable controller
System Manual, V4.2, 09/2016, A5E02486680-AK
675
Analog drive connection configuration
eral configuration dialog, you select the
"Analog drive connection" radio button
Unit of measurement
In the Drive configuration dialog, you select the
following parameters:
Analog drive hardware outputs
Data exchange drive velocities
Note: The Maximum speed must be greater
than or equal to the Reference (nominal) speed.
In the Encoder configuration dialog, you select the
following parameters:
Analog drive encoder coupling (for example, a
high-speed counter (HSC))
HSC interface
Encoder type
Fine resolution
To Next Page
Loading...
