Using the Scratchpad 393
a) Click and hold one tick mark, and move it on the axis. The spacing
and number of tic marks increases (or decreases) on both axes.
b) To adjust the scale and tic mark spacing on a single axis, press and
hold
g, and then grab and drag a tic mark on that axis.
4. Change axis end values by double-clicking them and typing new
values.
5. Adjust the location of the axes. To move the existing axes without
resizing or rescaling them, click in and drag an empty region of the
screen until the axes are in the desired location.
6. Change the axes’ scales by pressing
b41.
Type the values of your choice over the current values for x-min,
x-max, y-min, and y-max and click
OK.
7. Press b21 to hide or show the axes.
• If the axes are shown on the page, selecting this tool hides them.
• If the axes are hidden on the page, selecting this tool redisplays
them.
Tracing a graphed function
Graph Trace moves through the points of a graphed function,
parametric, polar, sequence, or scatter plot. To enable the trace tool:
1. Press
b51 to move across the points in a graphed function
in Trace model.
2. (Optional) To change the step increment for tracing, press
b53.
To Next Page
Loading...
Need help?
General
