547 Programmable Hardware Manual (PHM)
© Tibbo Technology Inc.
order to be able to support BLE upgrades is V3.00B ("B" stands for BLE). Additionally,
BLE updates require the WA2000 Wi-Fi/BLE add-on module to be attached.
BLE upgrades can be used to upload new TiOS firmware, Tibbo BASIC/C application,
and even the internal firmware and the internal Monitor/Loader of the WA2000!
If the M/L of your device is too old to support BLE updates, you can update the M/L
itself by running the Monitor/Loader Upgrader app.
BLE updates are also referred to as over-the-air (OTA) updates.
Prerequisites
To perform a BLE update:
·
You must have the file you will be sending into your device. BLE upgrades use
Tibbo Composite Uncompressed (.TCU) firmware files. All TiOS firmware and
related files are published here: http://tibbo.com/support/downloads/tios.html.
You can also produce .TCU files using our online tool found at
http://apps.tibbo.com/tc_generator/.
·
You will have to install the Tibbo Updater app (available for iOS and Android) on
your compatible device.
·
There are three ways of accessing .TCU files from the app:
o You can select one of Tibbo's officially released .TCU files (it is not possible to
access your own .TCU files in this manner);
o You can open a .TCU file that you previously saved on your device or in the
iCloud or Dropbox folder; or
o You can "copy" (export, share) a .TCU file to the Tibbo Updater app from some
other app that has this file. For example, you can email a .TCU file as an
attachment and open this email in the email client app on your iOS/Android
device. You can then "copy" the attached file to the Tibbo Updater app.
To Next Page
Loading...
Need help?
General