548Monitor/Loader (M/L)
© Tibbo Technology Inc.
·
You will need to be able to push the MD button on your Tibbo device (or pull the
MD line LOW).
·
Optional: you will benefit from observing the signals displayed by Status Green and
Status Red LEDs of your Tibbo device.
Update procedure
·
Disconnect your Tibbo device from the Ethernet (this will allow it to enter the BLE
update mode).
·
Turn your device off if it was on. Press and hold the MD button (or pull the MD line
LOW) and apply power to your device.
·
Release the MD button (line). The Green status LED will turn on.
·
After about 15 seconds (the time allotted to attempting to establish an Ethernet
link), the Green status LED will turn off, and the red status LED will turn on for
about 2 seconds, indicating that the WA2000 is booting up.
·
After that, the Green status LED will be on again. This will indicate that your
device is ready for a BLE update.
To Next Page
Loading...
Need help?
General