Phaser 6180 Color Laser Printer Service Manual 3-11
Error Messages and Codes
5 Perform the Registration Sensor test
(page 4-29): Service Mode > Engine
Diag > Sensor Test > Regi Sensor.
Does the number on the Control Panel
increase by 1 when the Actuator of the
Registration Sensor is activated?
Go to step 11. Go to step 6.
6 Check the wiring harness connectors
P/J23, P/J232, and P/J2322 between
the MCU Board and the Registration
Sensor. Are the connectors securely
connected?
Go to step 7. Reconnect the
connectors.
7 Check the Registration Sensor
Harness for continuity.
1. Disconnect P/J232 and P/J2322.
2. Check continuity between P/J232
<=> P/J2322.
Go to step 8. Replace the
Registration
Sensor
Harness.
8 Check the Right Side Harness for
continuity.
1. Disconnect P/J23 and P/J232.
2. Check continuity between P/J23 <=>
P/J232.
Go to step 9. Replace the
Right Side
Harness.
9 Check the Registration Sensor signal.
1. Disconnect P/J23 on the MCU
Board.
2. Is there +3.3 V across ground <=>
J23-8?
Go to step 10. Replace the
MCU Board
(page 8-87).
10 Check the Registration Sensor for
signal.
1. Measure the voltage across ground
<=> J23-10 on the MCU Board.
2. Does the voltage change when the
Actuator of the Registration Sensor
is activated?
Replace the
MCU Board
(page 8-87).
Replace the
Feeder
(page 8-43).
11 Perform the Tray 2 Motor test
(page 4-42): Service Mode > Engine
Diag > Motor Test > Tray 2 Motor.
Does the Motor operate?
Go to step 15. Go to step 12.
12 Check the wiring harness connectors
P/J25 and P/J251 between the MCU
Board and the Tray 2 Motor. Are the
connectors securely connected?
Go to step 13. Connect the
connectors.
13 Check the Right Side Harness for
continuity.
1. Disconnect P/J25 and P/J251.
2. Check continuity between P/J25 <=>
P/J251.
Go to step 14. Replace the
Right Side
Harness.
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No
To Next Page
Loading...
