Parameter Values (Range) Unit Step Default Description
Client IP 0.0.0.0 Sets the IP address of the client. If set to zero,
connection from any client is accepted.
Write authority 0=Read only
1=Disable 0x write
2=Full access
2=Full access Selects the control authority scheme
Time format 0=UTC
1=Local
1=Local Selects between UTC and local time for events
and timestamps.
Event ID selection 0=Address
1=UID
0=Address Selects whether the events are reported using
the MB address or the UID number.
Event buffering 0=Keep oldest
1=Keep newest
0=Keep oldest Selects whether the oldest or newest events
are kept in the case of event buffer overflow.
Event backoff 1...500 1 200 Defines how many events have to be read after
event buffer overflow to allow new events to be
buffered. Applicable in "Keep oldest" mode
only.
ControlStructPWd 1
**** Password for control operations using Control
Struct mechanism, which is available on 4x
memory area.
ControlStructPWd 2
**** Password for control operations using Control
Struct mechanism, which is available on 4x
memory area.
ControlStructPWd 3
**** Password for control operations using Control
Struct mechanism, which is available on 4x
memory area.
ControlStructPWd 4
**** Password for control operations using Control
Struct mechanism, which is available on 4x
memory area.
ControlStructPWd 5
**** Password for control operations using Control
Struct mechanism, which is available on 4x
memory area.
ControlStructPWd 6
**** Password for control operations using Control
Struct mechanism, which is available on 4x
memory area.
ControlStructPWd 7
**** Password for control operations using Control
Struct mechanism, which is available on 4x
memory area.
ControlStructPWd 8
**** Password for control operations using Control
Struct mechanism, which is available on 4x
memory area.
1MAC059074-MB A Section 3
Basic functions
615 series ANSI 65
Technical Manual
To Next Page
Loading...
