Configuring Standard VLANs Introduction
4-57
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
SET VLAN FORWARDINGMODE
Description Changes the type of VLANs specified to either Standard or Upstream Forwarding Only
(UFO). For information on UFO VLANs refer to Upstream Forwarding Only (UFO)
Mode.
Syntax
SET VLAN={ vlanname-list | vid-range } FORWARDINGMODE={ STD |
UPSTREAMONLY }
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example SET VLAN=4004 FORWARDINGMODE=UPSTREAMONLY
Option Description Default Value
VLAN A comma-delimited list of VLAN names or VLAN
number range (e.g., 4-6).
FORWARDING-
MODE
STANDARD - Traffic can be forwarded to either
upstream or downstream interfaces.
UPSTREAMONLY - Traffic can only be forwarded
to upstream interfaces.
To Next Page
Loading...
