Configuring Port Authentication Introduction
6-115
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
ENABLE DOT1X INTERFACE
Syntax
ENABLE DOT1X INTERFACE={ type:id-range | id-range | ifname-list |
ALL }
Description This command enables 802.1X Port Authentication on the interface specified. For the
feature to be enabled, DOT1X must already be enabled at the system level.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example ENABLE DOT1X INTERFACE=6.22-6.23
Option Description Default Value
INTERFACE The ethernet interfaces over which the 802.1X feature
will be enabled.
N/A
To Next Page
Loading...
Need help?
General
