ALTUS Nexto Series User Manual

5. CONFIGURATION
Settings Description Standard Options
Hot Swap Mode Module hot swap mode
Enabled,
no match
consistency.
(may vary
according to
CPU model)
- Denabled, only for de-
clared modules
- Disabled (with match con-
sistency)
- Disabled, no match consis-
tency
- Enabled, with match con-
sistency only for declared
modules
- Enabled, with match con-
sistency
- Enabled, no match consis-
tency
TCP/IP Parameters
Initial Time-out (x100 ms)
Indicates how long after the
first transmission of a mes-
sage, it should be retrans-
mitted, assuming it was not
received by the recipient.
At each retransmission the
time-out is doubled.
2
1 to 75
ACK Delay (x10 ms)
Timeout for sending a con-
firmation command.
10
0 to 100
Project Parameters
Consist retain and persis-
tent area in%Q
Configuration to consist of
addressable persistent and
retentive memories.
unmarked
- Checked: Consists of ad-
dressable persistent and re-
tentive memories
- Unchecked: Does not con-
sist of addressable persistent
and retentive memories.
Enable I/O update per task
Setting to update inputs and
outputs in the tasks in which
they are used.
unmarked
- Checked: Inputs and out-
puts are updated by the tasks
in which they are used.
- Unchecked: Inputs and
outputs are only updated by
MainTask
Enable retain and persis-
tent variables in Function
Blocks
Setting that allows the use of
retentive and persistent vari-
ables in Function Blocks
unmarked
- Marked: allows the use of
retentive and persistent vari-
ables in Function Blocks.
- Unchecked: Exception er-
ror may occur at startup.
Table 42: CPU settings
Notes:
Generate error on tasks watchdog consistency: This parameter was discontinued as of MasterTool IEC XE version 1.32.
Enable I/O update per task: This parameter was added as of MasterTool IEC XE version 2.01.
Consist retain and persistent area in %Q: If the user application declare retain or persistent variables mapped at %Q
addresses out of the areas configured, those variables will not persist after power down, reset warm or download. With
this parameter marked, MasterTool will check the code and generate error at compile time for this situation. It’s strongly
recommended to keep this parameter marked.
60

ALTUS Nexto Series Specifications

General

Brand	ALTUS
Model	Nexto Series
Category	Computer Hardware
Language	English