6-24
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Preconfigured System Alarm Notifications
Note LPM may delete files that you want to keep. You should act immediately when you receive the
LogPartitionHighWaterMarkExceeded alert.
Table 6-10 provides the default configuration for the LogPartitionHighWaterMarkExceeded RTMT
Alert.
LogPartitionLowWaterMarkExceeded
This alert occurs when the LogPartitionLowWaterMarkExceeded event gets generated. This indicates
that the percentage of used disk space in the log partition exceeded the configured low water mark.
Note Be aware that this alert is an early warning. The administrator should start freeing up disk space.
Using RTMT/TLC, you can collect trace/log files and delete them from the server. The
administrator should adjust the number of trace files that are kept to avoid hitting the low water
mark again.
Table 6-11 provides the default configuration for the LogPartitionLowWaterMarkExceeded RTMT
Alert.
Table 6-10 Default Configuration for the LogPartitionHighWaterMarkExceeded
RTMT Alert
Value Default Configuration
Enable Alert Selected
Severity Critical
Enable/Disable this
alert on the
following servers
Enabled on listed servers
Threshold Trigger alert when following condition met:
Log Partition Used Disk Space Exceeds High Water Mark (95%)
Duration Trigger alert immediately
Frequency Trigger alert on every poll
Schedule 24 hours daily
Enable E-mail Selected
Trigger Alert Action Default
Table 6-11 Default Configuration for the LogPartitionLowWaterMarkExceeded RTMT Alert
Value Default Configuration
Enable Alert Selected
Severity Critical
Enable/Disable this
alert on the
following servers
Enabled on listed servers