8-28
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 8 Industry-Standard Management Information Base
RFC1213-MIB (MIB-II)
Frequently Asked Questions
When the CCMVersion MIB and sysApplRunCurrentState returns incorrect values in Cisco Unified CM
Release 4.x, refer to CSCsk74156 to check if it is being hit. Verify if the fix for the defect has gone into
the Cisco Unified CM version used by customer.
When the SNMP walk on sysApp MIB is not responding, refer to CSCsh72473 to check if it is being hit.
Verify if the fix for the defect has gone into the Cisco Unified CM version used by customer.
RFC1213-MIB (MIB-II)
Note This is a reformatted version of MIB-II. Download and compile all of the MIBs in this section from
http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2.
Before you can compile RFC1213-MIB, you need to compile the MIBs listed below in the order listed.
1. SNMPv2-SMI
2. SNMPv2-TC
3. IANAifType-MIB
4. RFC1155-SMI
5. RFC-1212
6. RFC1213-MIB
The following are contained in this section:
• Revisions, page 8-29
• Definitions, page 8-29
• Object Identifiers, page 8-29
• Textual Conventions, page 8-29
• Groups in MIB-II, page 8-29
• Historical, page 8-30
• System Group, page 8-30
• Interfaces Group, page 8-32
• Address Translation Group, page 8-37
• IP Group, page 8-39
• ICMP Group, page 8-50
• TCP Group, page 8-55
• UDP Group, page 8-60
• EGP Group, page 8-62
• SNMP Group, page 8-67
To Next Page
Loading...
