6-239
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Warning-Level Alarms
H323Stopped
Cisco CallManager is not ready to handle calls for the indicated H323 device.
Cisco Unified Communications Manager (Unified CM) is not ready to handle calls for the indicated
H.323 device. This could be due to Unified CM being unable to resolve the gateway name to IP address.
For trunks, this alarm should only occur when a system administrator has made a configuration change
such as resetting the H.323 trunk. For H.323 clients, this alarm occurrence is normal on lower-priority
Unified CM nodes when a high-priority Unified CM node starts.
Facility/Sub-Facility
CCM_CALLMANAGER-CALLMANAGER
Cisco Unified Serviceability Alarm Definition Catalog
CallManager/CallManager
Severity
Warning (4)
Parameters
Device Name. [String] IP Address [String] Device type. [Optional] [Enum]Device description
[Optional]. [String] Remote CallManager Server 1[Optional]. [String] Remote CallManager Server
2[Optional]. [String] Remote CallManager Server 3[Optional]. [String]
Enum Definitions for DeviceType
Recommended Action
If the service was stopped intentionally, no action is required. Check the domain name system (DNS)
configuration for any errors in the gateway name or IP address and correct.
History
Cisco Unified Communications
Release Action
8.0(1) Following information updated:
• Parameters
• Enum Definitions for DeviceType
Code Device Type
61 H323_PHONE
62 H323_GATEWAY
122 GATEKEEPER
125 TRUNK
To Next Page
Loading...
Need help?
General