7-144
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 7 Cisco Management Information Base
CISCO-SYSLOG-MIB
CISCO-SYSLOG-MIB
Note This is a reformatted version of CISCO-SYSLOG-MIB. Download and compile all of the MIBs in this
section from http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2.
This MIB provides a means to gather syslog messages generated by the Cisco IOS. Various textual
messages are generated by the Cisco IOS. Cisco IOS can be configured such that these messages are sent
to a syslog server. With this MIB these same messages can also be received via the SNMP. These
messages are hereupon referred to as syslog messages in this document.
Note Messages generated as a result of entering CLI debug commands are not made available via the SNMP
at this time.
All Cisco IOS syslog messages have timestamps (optional), facility names (where the message came
from), severity, message name, and message text. The following example is often seen:
%SYS-5-CONFIG_I: configured from console where facility=SYS, severity=5, message
name=CONFIG_I.
Before you can compile CISCO-SYSLOG-MIB, you need to compile the MIBs listed below in the order
listed.
1. SNMPv2-SMI
2. SNMPv2-TC
3. SNMPv2-CONF
4. CISCO-SMI
5. INET-ADDRESS-MIB
6. SNMP-FRAMEWORK-MIB
7. RFC1155-SMI
8. RFC-1212
9. RFC-1215
10. SNMPv2-TC-v1
11. CISCO-SYSLOG-MIB
Additional downloads are:
• OID File: CISCO-SYSLOG-MIB.oid
• Capability File: CISCO-SYSLOG-CAPABILITY
The following are contained in this section:
• Revisions, page 7-145
• Definitions, page 7-145
• Object Identifiers, page 7-145
• Textual Conventions, page 7-145
To Next Page
Loading...
Need help?
General