6-393
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Informational-Level Alarms
Unified CM received a Publish Revoke message or Withdraw message from the SAF Forwarder but the
service ID in the message is not recognized by Unified CM. Unified CM may not recognize the service
ID if the service ID was mistyped in the publish revoke CLI command, or if the service was previously
withdrawn.
Cisco Unified Serviceability Alarm Catalog
CallManager/CallManager
Severity
Informational(6)
Routing List
SDL
SDI
Sys Log
Event Log
Parameters
Client Handle(String)
Service ID(UInt)
Sub Service ID(UInt)
InstanceID1(UInt)
InstancID2(UInt)
InstanceID3(UInt)
InstanceID4(UInt)
Recommended Action
None
SecurityEvent
Failed to write into the primary file path. Audit Event is generated by this application.
Cisco Unified Serviceability Alarm Catalog
AuditLog
Severity
INFORMATIONAL
Recommended Action
Ensure that the primary file path is valid and the corresponding drive has sufficient disk space. Also,
make sure that the path has security permissions similar to default log file path.
To Next Page
Loading...
Need help?
General