7-121
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 7 Cisco Management Information Base
CISCO-CCM-CAPABILITY
• SOAP interface
• Real-TimeMonitoringTool (RTMT) alerts
There is a ccmCallManagerFailed trap for Cisco Unified CM service failure. But this does not cover
normal service stop and unknown crashes.
The device pool information seems incorrect for any device polled for. The OID used is
ccmPhoneDevicePoolIndex.
As stated in the CISCO-CCM-CAPABILITY MIB, ccmPhoneDevicePoolIndex is not supported, hence
it returns 0. The CallManager device registration alarm currently does not contain the devicepool
information.
CISCO-CCM-CAPABILITY
Note This is a reformatted version of CISCO-CCM-CAPABILITY. Download and compile all of the MIBs in
this section from http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2.
Note This MIB is not meant to perform SNMP queries like MIB walk as there is no agent supporting this MIB.
It is only used as documentation supplement to the CISCO-CCM-MIB.
Before you can compile CISCO-CCM-CAPABILITY, you need to compile the MIBs listed below in the
order listed.
1. SNMPv2-SMI
2. SNMPv2-TC
3. SNMPv2-CONF
4. SNMPv2-MIB
5. IANAifType-MIB
6. IF-MIB
7. CISCO-SMI
8. SNMP-FRAMEWORK-MIB
9. RMON-MIB
10. CISCO-TC
11. CISCO-VTP-MIB
12. RFC1155-SMI
13. RFC-1212
14. SNMPv2-TC-v1
15. CISCO-CDP-MIB
16. CISCO-CCM-CAPABILITY
To Next Page
Loading...
Need help?
General