CHAPTER
8-1
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
8
Industry-Standard Management Information
Base
This chapter describes the industry-standard Management Information Base (MIB) text files that are
supported by Cisco Unified Communications Manager (Cisco Unified CM) and used with Simple
Network Management Protocol (SNMP). It contains the following sections:
• SYSAPPL-MIB, page 8-1
• RFC1213-MIB (MIB-II), page 8-28
• HOST-RESOURCES-MIB, page 8-73
• IF-MIB, page 8-105
SYSAPPL-MIB
Note This is a reformatted version of SYSAPPL-MIB. Download and compile all of the MIBs in this section
from http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2.
The MIB module defines management objects that model applications as collections of executables and
files installed and executing on a host system. The MIB presents a system-level view of applications;
i.e., objects in this MIB are limited to those attributes that can typically be obtained from the system
itself without adding special instrumentation to the applications.
Before you can compile SYSAPPL-MIB , you need to compile the MIBs listed below in the order listed.
1. RFC1155-SMI
2. RFC-1212
3. SNMPv2-SMI-v1
4. SNMPv2-TC-v1
5. SYSAPPL-MIB
Additional downloads are:
• OID File: SYSAPPL-MIB.oid
To Next Page
Loading...
