9-20
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 9 Vendor-Specific Management Information Base
Hewlett Packard MIBs
HP Status Messages
Table 9-13 lists status messages, MIBs and OIDs, MIB object names and clearing values, and object
responses.
CPQTHRSH-MIB 1.3.6.1.4.1.232.10 Provides alarm threshold management
CPQHOST-MIB 1.3.6.1.4.1.232.11 Provides operating system information
CPQIDE-MIB 1.3.6.1.4.1.232.14 Provides IDE (CD-ROM) drive status/events
CPQNIC-MIB 1.3.6.1.4.1.232.18 Provides Network Interface Card (NIC)
status/events
Table 9-12 HP MIBs (continued)
MIB OID Function
Table 9-13 HP Hardware Status Messages, MIBs and OIDs, MIB Object Names and Clearing Values, and
Object Responses
Cisco Unified CM Release 6.x
MCS-78xx Status MIB and OID
MIB Object Name and
Clearing Value Object Response
Logical Drive
1
CPQIDA-MIB
1.3.6.1.4.1.232.3.2.3.1.1.4
cpqDaLogDrvStatus
Clearing Value = 2
The logical drive can be in one of the
following states:
• Ok (2) Indicates that the logical
drive is in normal operation mode.
• Failed (3) Indicates that more
physical drives have failed than the
fault tolerance mode of the logical
drive can handle without data loss.
• Unconfigured (4) Indicates that the
logical drive is not configured.
• Recovering (5) Indicates that the
logical drive is using Interim
Recovery Mode. In Interim
Recovery Mode, at least one
physical drive has failed, but the
logical drive's fault tolerance mode
lets the drive continue to operate
with no data loss.
• Ready Rebuild (6) Indicates that
the logical drive is ready for
Automatic Data Recovery. The
physical drive that failed has been
replaced, but the logical drive is
still operating in Interim Recovery
Mode.
To Next Page
Loading...
Need help?
General