6-51
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Preconfigured CallManager Alarm Notifications
TCPSetupToIMEFailed
This alert occurs when Cisco Unified Communications Manager cannot establish a TCP connection to a
Cisco IME server. This alert typically occurs when the IP address and port of the Cisco IME server are
misconfigured in Cisco Unified Communications Manager Administration or when an Intranet
connectivity problem exists and prevents the connection from being set up.
Ensure that the IP address and port of the Cisco IME server in the alert are valid. If the problem persists,
test the connectivity between the Cisco Unified Communications Manager servers and the Cisco IME
server.
TLSConnectionToIMEFailed
This alert occurs when a TLS connection to the Cisco IME service could not be established because the
certificate presented by the Cisco IME service has expired or is not in the Cisco Unified Communications
Manager CTL.
Ensure that the Cisco IME service certificate has been configured into the Cisco Unified
Communications Manager.
Default Configuration
Table 6-54 Default Configuration for the TCPSetupToIMEFailed Alert
Value Default Configuration
Enable Alert Selected
Severity Critical
Enable/Disable this
alert on the
following servers
Enabled on listed servers
Threshold Trigger alert when following condition met:
Connection Failure to Cisco IME server
Duration Trigger alert immediately
Frequency Trigger alert on every poll
Schedule 24 hours daily
Enable E-mail Selected
Trigger Alert Action Default
Table 6-55 Default Configuration for the TLSConnectionToIMEFailed Alert
Value Default Configuration
Enable Alert Selected
Severity Alert
Enable/Disable this
alert on the
following servers
Enabled on listed servers
To Next Page
Loading...
Need help?
General