8-45
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 8 Industry-Standard Management Information Base
RFC1213-MIB (MIB-II)
::= { ipAddrEntry 5 }
IP Routing Table
-- The IP routing table contains an entry for each route
-- presently known to this entity.
ipRouteTable OBJECT-TYPE
SYNTAX Sequence of ipRouteEntry
ACCESS not-accessible
STATUS mandatory
DESCRIPTION
This entity IP Routing table.
::= { ip 21 }
ipRouteEntry OBJECT-TYPE
SYNTAX IpRouteEntry
ACCESS not-accessible
STATUS mandatory
DESCRIPTION
A route to a particular destination.
INDEX { ipRouteDest }
::= { ipRouteTable 1 }
IpRouteEntry ::=
SEQUENCE { ipRouteDest IpAddress, ipRouteIfIndex INTEGER, ipRouteMetric1 INTEGER,
ipRouteMetric2 INTEGER, ipRouteMetric3 INTEGER, ipRouteMetric4 INTEGER,
ipRouteNextHop IpAddress, ipRouteType INTEGER, ipRouteProto INTEGER, ipRouteAge
INTEGER, ipRouteMask IpAddress, ipRouteMetric5 INTEGER, ipRouteInfo OBJECT
IDENTIFIER }
ipRouteDest OBJECT-TYPE
SYNTAX IpAddress
ACCESS read-write
STATUS mandatory
DESCRIPTION
The destination IP address of this route. An entry with a value of 0.0.0.0 is considered a default
route. Multiple routes to a single destination can appear in the table, but access to such multiple
entries is dependent on the table-access mechanisms defined by the network management protocol
in use.
::= { ipRouteEntry 1 }
ipRouteIfIndex OBJECT-TYPE
SYNTAX Integer
ACCESS read-write
To Next Page
Loading...
Need help?
General