7-14
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 7 Cisco Management Information Base
CISCO-CCM-MIB
Definitions
The following definitions are imported for CISCO-CCM-MIB:
• MODULE-IDENTITY, OBJECT-TYPE, NOTIFICATION-TYPE, IpAddress, Counter32,
Integer32, Unsigned32
• From SNMPv2-SMI—DateAndTime, TruthValue, MacAddress, TEXTUAL-CONVENTION
• From SNMPv2-TC—SnmpAdminString
• From SNMP-FRAMEWORK-MIB—MODULE-COMPLIANCE, OBJECT-GROUP,
NOTIFICATION-GROUP
• From SNMPv2-CONF—ciscoMgmt
• From CISCO-SMI—InetAddressType, InetAddress, InetPortNumber
• From INET-ADDRESS-MIB
Textual Conventions
CcmIndex ::= TEXTUAL-CONVENTION
DISPLAY-HINT d
STATUS current
DESCRIPTION
This syntax is used as the Index into a table. A positive value is used to identify a unique entry in
the table.
SYNTAX Unsigned32(1..4294967295)
CcmIndexOrZero ::= TEXTUAL-CONVENTION
DISPLAY-HINT d
STATUS current
DESCRIPTION
This textual convention is an extension of the CcmIndex convention. The latter defines a greater than
zero to identify an entry of the CCM MIB table in the managed system. This extension permits the
additional value of zero. The value zero is object-specific and must be defined as part of the
description of any object that uses this syntax.
SYNTAX Unsigned32 (0..4294967295)
CcmDevRegFailCauseCode ::= TEXTUAL-CONVENTION
STATUS current
DESCRIPTION
This syntax is used as means of identifying the reasons for a device registration failure. The scope
of this enumeration can expand to comply with RFC 2578.
noError: No Error
unknown: Unknown error cause
noEntryInDatabase: Device not configured properly in the Cisco Unified CM database
databaseConfigurationError: Device configuration error in the Cisco Unified CM database
To Next Page
Loading...
Need help?
General