7-152
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 7 Cisco Management Information Base
CISCO-SYSLOG-EXT-MIB
• Enterprise Parameters configuration is used by the Cisco Syslog Agent to send the messages.
Corresponding application Alarm configuration will use the alarm interface to send to remote syslog
server configured.
• If the "Local Syslogs" Alarm is enabled in Alarm page, there will be duplication of the service
specific messages, incase the same remote server is configured in both pages (provided the severity
conditions are matched). For example: Enterprise window has severity level as "Error", Alarm page
has severity "Debug" and "Local syslogs" alarm is enabled. If a syslog message of a particular
service configured via alarm page, has a severity higher than 'Debug' and 'Error', then it will be
duplicated.
Does the SysLog subagent generate traps for the alarms in Syslog automatically? Is there any
configuration? Syslog subagent can be configured to generate traps for the syslog alarms. Some
limitations are:
• Traps are sent out based on selected severity. If the given alarm is of low severity then the
management application needs to set the severity threshold lower to capture this low severity
alarm/trap. In other words mgmt apps need to deal with flooding of other low severity traps.
• SNMP Trap message size limited to 255 and not enabled by default. i.e. by default
clogsNotificationEnabled (1.3.6.1.4.1.9.9.41.1.1.2) is set to FALSE (2).
CISCO-SYSLOG-EXT-MIB
Note This is a reformatted version of CISCO-SYSLOG-EXT-MIB. Download and compile all of the MIBs in
this section from http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&step=2.
Before you can compile CISCO-SYSLOG-EXT-MIB, you need to download and compile the MIBs
listed below in the order listed.
1. SNMPv2-SMI
2. SNMPv2-TC
3. SNMPv2-CONF
4. CISCO-SMI
5. INET-ADDRESS-MIB
6. SNMP-FRAMEWORK-MIB
7. CISCO-SYSLOG-MIB
8. RFC1155-SMI
9. RFC-1212
10. SNMPv2-TC-v1
11. CISCO-SYSLOG-EXT-MIB
Additional downloads are:
• OID File: CISCO-SYSLOG-EXT-MIB.oid
• Capability File: CISCO-SYSLOG-EXT-CAPABILITY
The following are contained in this section:
To Next Page
Loading...
Need help?
General