Cisco MCS-7825-H3-IPC1 User Manual

6-313
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Notice-Level Alarms
Recommended Action
Informational purposes only; no action is required.
MaxCallDurationTimeout
An active call was cleared because the amount of time specified in the Maximum Call Duration Timer
service parameter had elapsed. If the allowed call duration is too short, you can increase the value. If you
do not want a limit on the duration of an active call, you can disable the limit. If the duration is correct
but you did not expect a call to ever exceed that duration, check the trace information around the time
that this alarm occurred to try to determine if a gateway port had failed to release a call.
Facility/Sub-Facility
CCM_CALLMANAGER-CALLMANAGER
Cisco Unified Serviceability Alarm Definition Catalog
CallManager/CallManager
Severity
Notice
Parameters
Maximum Call Duration (minutes) [UInt]
Originating Device name(String)
Destination Device name(String)
Call start time(UInt)
Call stop time(UInt)
Calling Party Number(String)
Called Party Number(String)
History
Cisco Unified Communications
Release Action
8.0(1)
• Severity changed from Informational to Notice.
• Following parameters added:
– Originating Device name(String)
– Destination Device name(String)
– Call start time(UInt)
– Call stop time(UInt)
– Calling Party Number(String)
– Called Party Number(String)

Cisco MCS-7825-H3-IPC1 Specifications

General

Brand	Cisco
Model	MCS-7825-H3-IPC1
Category	Software
Language	English