6-349
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Informational-Level Alarms
Severity
Informational
Parameters
None
Recommended Action
None
DefaultDurationInCacheModified
Default value of a Certificate duration in cache is modified in the Service Parameter page. This usually
means that the Default Certificate duration in cache value is modified in the Service Parameter page.
Cisco Unified Serviceability Alarm Catalog
System/TVS
Severity
INFORMATIONAL
Routing List
SDI
Event Log
Data Collector
Sys Log
Recommended Action
None
DeviceApplyConfigInitiated
Device Apply Config initiated.
This alarm occurs when a system administrator presses the Apply Config button in Cisco Unified
Communications Manager (Unified CM). The Apply Config button initiates a conditional restart on
devices that support conditional restart. This button triggers the system to determine if any relevant
configuration has changed for the device. If the configuration changes can be applied dynamically, they
are made without service interruption. If a change requires that the device reregister with Unified CM,
reregistration occurs automatically. If a change requires a restart, the device will be automatically
restarted. If the load ID for a device changes, the device will initiate a background download of the new
firmware. The new firmware can then be applied immediately or at a later time. For phones and devices
that do not support conditional restart, clicking Apply Config causes these devices to restart.
Severity
Informational
Routing List
SDL
To Next Page
Loading...
Need help?
General