6-224
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Warning-Level Alarms
Enum Definitions
80 VOICE_MAIL_PORT
83 SOFTWARE_MEDIA_TERMINATION_POINT_HDV2
84 CISCO_MEDIA_SERVER
85 CISCO_VIDEO_CONFERENCE_BRIDGE
90 ROUTE_LIST
100 LOAD_SIMULATOR
110 MEDIA_TERMINATION_POINT
111 MEDIA_TERMINATION_POINT_HARDWARE
112 MEDIA_TERMINATION_POINT_HDV2
113 MEDIA_TERMINATION_POINT_WS-SVC-CMM
120 MGCP_STATION
121 MGCP_TRUNK
122 GATEKEEPER
124 7914_14_BUTTON_LINE_EXPANSION_MODULE
125 TRUNK
126 TONE_ANNOUNCEMENT_PLAYER
131 SIP_TRUNK
132 SIP_GATEWAY
133 WSM_TRUNK
134 REMOTE_DESTINATION_PROFILE
227 7915_12_BUTTON_LINE_EXPANSION_MODULE
228 7915_24_BUTTON_LINE_EXPANSION_MODULE
229 7916_12_BUTTON_LINE_EXPANSION_MODULE
230 7916_24_BUTTON_LINE_EXPANSION_MODULE
232 CKEM_36_BUTTON_LINE_EXPANSION_MODULE
254 UNKNOWN_MGCP_GATEWAY
255 UNKNOWN
30027 ANALOG_PHONE
30028 ISDN_BRI_PHONE
30032 SCCP_GATEWAY_VIRTUAL_PHONE
Code Reason
1 Unknown—(SCCP only) The device failed to register for an unknown reason. If this persists,
collect SDL/SDI traces with "Enable SCCP Keep Alive Trace" enabled and contact TAC.
2 NoEntryInDatabase—(MGCP only) The device is not configured in the Unified CM
Administration database and auto-registration is either not supported for the device type or is
not enabled. To correct this problem, configure this device in Unified CM Administration.
To Next Page
Loading...
Need help?
General