9 Maintenance
Personnel:
n
Mechanic
n
Qualified electrician
n
Service personnel
The wearing and spare parts belonging to the pump type can be identified on
the basis of the pump key.
The pump key (
Ä
Chapter 13.3 ‘‘EcoPro’ pump key’ on page 75) can be
found on the type plate (
Ä
Chapter 13.2 ‘Equipment marking / Type plate’
on page 74) of the pump.
Before maintenance is carried out, stocks of the pump-specific wearing and
spare parts (
Ä
Chapter 10 ‘Consumables and spare parts’ on page 61)
should be obtained.
For all queries to the manufacturer, it is important that the designation
and the pump type are quoted correctly. This is the only way to ensure
fast and accurate processing.
DANGER!
Damage and injuries may occur if installation, maintenance or repair
work is carried out incorrectly
.
Maintenance and repair work may only be performed by authorised and trained
specialist personnel in compliance with current local regulations.
The safety regulations and required protective clothing (PPE) must be
complied with when working with chemicals. Attention must be paid to the
information included on the product data sheet of the dosing medium used.
During or prior to maintenance and repair work:
–
Use only original spare parts.
– Depressurise the pressure line.
– Disconnect the dosing medium supply and clean the system thoroughly.
– Unplug the mains plug or disconnect the pump from all power sources, and
secure against accidental re-activation!
NOTICE!
Damage caused by using incorrect tools!
Damage may occur as a result of using incorrect tools during assembly
,
maintenance or troubleshooting. Only use the correct tools.
Maintenance
52417102264 Rev. 5-01.2019
To Next Page
Loading...
Need help?
General
