Edge-Core ECS4210-12P - Figure 52: Configuring the LACP Aggregator Admin Key; Figure 53: Enabling LACP on a Port

Chapter 4 | Interface Configuration
Trunk Configuration
– 121 –
Figure 52: Configuring the LACP Aggregator Admin Key
To enable LACP for a port:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Configure from the Action list.
4. Click General.
5. Enable LACP on the required ports.
6. Click Apply.
Figure 53: Enabling LACP on a Port
To configure LACP parameters for group members:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Configure from the Action list.
4. Click Actor or Partner.