Edge-Core ECS4210-12P - Displaying System Information

Chapter 3 | Basic Management Tasks
Displaying System Information
– 66 –
Displaying System Information
Use the System > General page to identify the system by displaying information
such as the device name, location and contact information.
Parameters
These parameters are displayed:
◆ System Description – Brief description of device type.
◆ System Object ID – MIB II object ID for switch’s network management
subsystem.
(ECS4210-12P: 1.3.6.1.4.1.259.10.1.42.104,
ECS4210-12T: 1.3.6.1.4.1.259.10.1.42.103,
ECS4210-28T: 1.3.6.1.4.1.259.10.1.42.101,
ECS4210-28P: 1.3.6.1.4.1.259.10.1.42.102)
◆ System Up Time – Length of time the management agent has been up.
◆ System Name – Name assigned to the switch system.
◆ System Location – Specifies the system location.
◆ System Contact – Administrator responsible for the system.
◆ System EEE – Enables or disables Energy Efficient Ethernet. When supported
by devices on both ends of a link, each side of the link can disable portions of
system functionality and save power during periods of low link utilization.
Support for EEE is advertised during link-up auto-negotiation.
Web Interface
To configure general system information:
1. Click System, General.
2. Specify the system name, location, and contact information for the system
administrator.
3. Click Apply.