– 17 –
Figures
Figure 1: Home Page 44
Figure 2: Front Panel Indicators 46
Figure 3: System Information 67
Figure 4: General Switch Information 68
Figure 5: Configuring Support for Jumbo Frames 69
Figure 6: Displaying Bridge Extension Configuration 70
Figure 7: Copy Firmware 72
Figure 8: Saving the Running Configuration 73
Figure 9: Setting Start-Up Files 74
Figure 10: Displaying System Files 75
Figure 11: Configuring Automatic Code Upgrade 78
Figure 12: Manually Setting the System Clock 80
Figure 13: Setting the Polling Interval for SNTP 81
Figure 14: Configuring NTP 82
Figure 15: Specifying SNTP Time Servers 82
Figure 16: Adding an NTP Time Server 83
Figure 17: Showing the NTP Time Server List 84
Figure 18: Adding an NTP Authentication Key 85
Figure 19: Showing the NTP Authentication Key List 85
Figure 20: Setting the Time Zone 86
Figure 21: Console Port Settings 88
Figure 22: Telnet Connection Settings 89
Figure 23: Displaying CPU Utilization 90
Figure 24: Displaying Memory Utilization 91
Figure 25: Restarting the Switch (Immediately) 93
Figure 26: Restarting the Switch (In) 94
Figure 27: Restarting the Switch (At) 94
Figure 28: Restarting the Switch (Regularly) 94
Figure 29: Configuring Connections by Port List 97
To Next Page
Loading...
Need help?
General
