Chapter 12
| Security Measures
Web Authentication
– 269 –
◆ Apply – Enables web authentication if the Status box is checked.
◆ Re-authenticate – Ends all authenticated web sessions for selected host IP
addresses in the Authenticated Host List, and forces the users to re-
authenticate.
◆ Revert – Restores the previous configuration settings.
Web Interface
To enable web authentication for a port:
1. Click Security, Web Authentication.
2. Select Configure Interface from the Step list.
3. Set the status box to enabled for any port that requires web authentication,
and click Apply
4. Mark the check box for any host addresses that need to be re-authenticated,
and click Re-authenticate.
Figure 172: Configuring Interface Settings for Web Authentication
To Next Page
Loading...
