EasyManuals Logo

Edge-Core ECS4210-12P Web Management Guide

Edge-Core ECS4210-12P
550 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #194 background imageLoading...
Page #194 background image
Chapter 7
| Spanning Tree Algorithm
Displaying Interface Settings for STA
– 194 –
Displaying Interface Settings for STA
Use the Spanning Tree > STA (Configure Interface - Show Information) page to
display the current status of ports or trunks in the Spanning Tree.
Parameters
These parameters are displayed:
◆ Spanning Tree – Shows if STA has been enabled on this interface.
◆ BPDU Flooding – Shows if BPDUs will be flooded to other ports when
spanning tree is disabled globally on the switch or disabled on a specific port.
◆ STA Status – Displays current state of this port within the Spanning Tree:
â– 
Discarding - Port receives STA configuration messages, but does not
forward packets.
â– 
Learning - Port has transmitted configuration messages for an interval set
by the Forward Delay parameter without receiving contradictory
information. Port address table is cleared, and the port begins learning
addresses.
â– 
Forwarding - Port forwards packets, and continues learning addresses.
The rules defining port status are:
â– 
A port on a network segment with no other STA compliant bridging device
is always forwarding.
â– 
If two ports of a switch are connected to the same segment and there is no
other STA device attached to this segment, the port with the smaller ID
forwards packets and the other is discarding.
â– 
All ports are discarding when the switch is booted, then some of them
change state to learning, and then to forwarding.
◆ Forward Transitions – The number of times this port has transitioned from the
Learning state to the Forwarding state.
◆ Designated Cost – The cost for a packet to travel from this port to the root in
the current Spanning Tree configuration. The slower the media, the higher the
cost.
◆ Designated Bridge – The bridge priority and MAC address of the device
through which this port must communicate to reach the root of the Spanning
Tree.
◆ Designated Port – The port priority and number of the port on the designated
bridging device through which this switch must communicate with the root of
the Spanning Tree.

Table of Contents

Other manuals for Edge-Core ECS4210-12P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS4210-12P and is the answer not in the manual?

Edge-Core ECS4210-12P Specifications

General IconGeneral
BrandEdge-Core
ModelECS4210-12P
CategoryNetwork Router
LanguageEnglish

Related product manuals