Chapter 6
| Address Table Settings
Changing the Aging Time
– 170 –
To show the static addresses assigned to an isolation mode:
1. Click MAC Address, Static.
2. Select Configure Static Address from the Step list.
3. Select Show from the Action list.
Figure 95: Displaying Interfaces Assigned a MAC Address Isolation Mode
Changing the Aging Time
Use the MAC Address > Dynamic (Configure Aging) page to set the aging time for
entries in the dynamic address table. The aging time is used to age out dynamically
learned forwarding information.
Parameters
These parameters are displayed:
◆ Aging Status – Enables/disables the function.
◆ Aging Time – The time after which a learned entry is discarded. (Range: 6-7200
seconds; Default: 300 seconds)
Web Interface
To set the aging time for entries in the dynamic address table:
1. Click MAC Address, Dynamic.
2. Select Configure Aging from the Action list.
3. Modify the aging status if required.
4. Specify a new aging time.
5. Click Apply.
To Next Page
Loading...
Need help?
General
