Chapter 12
| Security Measures
Network Access (MAC Address Authentication)
– 276 –
3. Click the Link Detection button.
4. Modify the link detection status, trigger condition, and the response for any
port.
5. Click Apply.
Figure 175: Configuring Link Detection for Network Access
Configuring a MAC
Address Filter
Use the Security > Network Access (Configure MAC Filter) page to designate
specific MAC addresses or MAC address ranges as exempt from authentication.
MAC addresses present in MAC Filter tables activated on a port are treated as pre-
authenticated on that port.
Command Usage
â—† Specified MAC addresses are exempt from authentication.
â—† Up to 65 filter tables can be defined.
â—† There is no limitation on the number of entries used in a filter table.
Parameters
These parameters are displayed:
◆ Filter ID – Adds a filter rule for the specified filter.
◆ MAC Address – The filter rule will check ingress packets against the entered
MAC address or range of MAC addresses (as defined by the MAC Address Mask).
◆ MAC Address Mask – The filter rule will check for the range of MAC addresses
defined by the MAC bit mask. If you omit the mask, the system will assign the
default mask of an exact match. (Range: 000000000000 - FFFFFFFFFFFF;
Default: FFFFFFFFFFFF)
To Next Page
Loading...
Need help?
General
