Edge-Core ECS4210-12P - Displaying Memory Utilization; Resetting the System; Figure 24: Displaying Memory Utilization

Chapter 3 | Basic Management Tasks
Displaying Memory Utilization
– 91 –
Displaying Memory Utilization
Use the System > Memory Status page to display memory utilization parameters.
Parameters
The following parameters are displayed:
◆ Free Size – The amount of memory currently free for use.
◆ Used Size – The amount of memory allocated to active processes.
◆ Total – The total amount of system memory.
Web Interface
To display memory utilization:
1. Click System, then Memory Status.
Figure 24: Displaying Memory Utilization
Resetting the System
Use the System > Reset menu to restart the switch immediately, at a specified time,
after a specified delay, or at a periodic interval.
Command Usage
◆ This command resets the entire system.
◆ To retain all configuration information stored in non-volatile memory, click the
Save button prior to resetting the system.
◆ When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory as
described under “Saving the Running Configuration to a Local File” on page 73.