Figures
– 19 –
Figure 65: Configuring VLAN Trunking 133
Figure 66: VLAN Compliant and VLAN Non-compliant Devices 136
Figure 67: Using GVRP 138
Figure 68: Creating Static VLANs 139
Figure 69: Modifying Settings for Static VLANs 140
Figure 70: Showing Static VLANs 140
Figure 71: Configuring Static Members by VLAN Index 143
Figure 72: Configuring Static VLAN Members by Interface 144
Figure 73: Configuring Static VLAN Members by Interface Range 144
Figure 74: Configuring Global Status of GVRP 146
Figure 75: Configuring GVRP for an Interface 147
Figure 76: Showing Dynamic VLANs Registered on the Switch 147
Figure 77: Showing the Members of a Dynamic VLAN 148
Figure 78: QinQ Operational Concept 149
Figure 79: Enabling QinQ Tunneling 153
Figure 80: Adding an Interface to a QinQ Tunnel 154
Figure 81: Configuring Protocol VLANs 156
Figure 82: Displaying Protocol VLANs 156
Figure 83: Assigning Interfaces to Protocol VLANs 158
Figure 84: Showing the Interface to Protocol Group Mapping 158
Figure 85: Configuring IP Subnet VLANs 160
Figure 86: Showing IP Subnet VLANs 160
Figure 87: Configuring MAC-Based VLANs 161
Figure 88: Showing MAC-Based VLANs 162
Figure 89: Configuring VLAN Mirroring 163
Figure 90: Showing the VLANs to Mirror 163
Figure 91: Configuring Static MAC Addresses 166
Figure 92: Displaying Static MAC Addresses 167
Figure 93: Setting Global Status for MAC Address Isolation 169
Figure 94: Configuring MAC Address Isolation 169
Figure 95: Displaying Interfaces Assigned a MAC Address Isolation Mode 170
Figure 96: Setting the Address Aging Time 171
Figure 97: Displaying the Dynamic MAC Address Table 172
Figure 98: Clearing Entries in the Dynamic MAC Address Table 173
Figure 99: Mirroring Packets Based on the Source MAC Address 174
To Next Page
Loading...
Need help?
General
