Configuring LLDP
13-8 Configuring Neighbor Discovery
Enable or disable transmitting and processing
received LLDPDUs on a port or range of ports.
set lldp port status {tx-enable | rx-
enable | both | disable} port-string
Enable or disable sending LLDP traps when a
remote system change is detected.
set lldp port trap {enable | disable}
port-string
Enable or disable sending an LLDP-MED trap when
a change in the topology has been sensed on the
port (that is, a remote endpoint device has been
attached or removed from the port).
set lldp port med-trap {enable |
disable} port-string
Configure LLDP-MED location information on a port
or range of ports. Currently, only Emergency Call
Services (ECS) Emergency Location Identification
Number (ELIN) is supported. ELIN is a special
phone number used to indicate location, and is
assigned and associated with small geographies in
the organization.It is one of the forms of identification
that the location identification TLV provides.
set lldp port location-info elin elin-
string port-string
Select the optional LLDP and LLDP-MED TLVs to be
transmitted in LLDPDUs by the specified port or
ports.
set lldp port tx-tlv {[all] | [port-
desc] [sys-name] [sys-desc] [sys-cap]
[mgmtaddr] [vlan-id] [stp] [lacp]
[gvrp] [mac-phy] [poe] [link-aggr]
[max-frame] [medcap] [med-pol] [med-
loc] [med-poe]} port-string
Configure network policy for a set of applications on
a port or range of ports. The policies configured with
this command are sent in LLDPDUs as LLDP-MED
Network Policy TLVs. Multiple Network Policy TLVs
can be sent in a single LLDPDU.
set lldp port network-policy {all |
voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice
| video-conferencing | streaming-video
| video-signaling} [state {enable |
disable}] [ tag {tagged | untagged}]
[vid {vlan-id | dot1p}] [cos cos-value]
[dscp dscp-value] port-string
Return LLDP parameters to their default values. clear lldp {all | tx-interval | hold-
multipler | trap-interval | med-fast-
repeat}
Return the port status to the default value of both
(both transmitting and processing received
LLDPDUs are enabled).
clear lldp port status port-string
Return the port LLDP trap setting to the default value
of disabled.
clear lldp port trap port-string
Return the port LLDP-MED trap setting to the default
value of disabled.
clear lldp port med-trap port-string
Return the port ECS ELIN location setting to the
default value of null.
clear lldp port location-info elin
port-string
Return network policy for a set of applications on a
port or range of ports to default values.
clear lldp port network-policy {all |
voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice
| video-conferencing | streaming-video
|
video-signaling} {[state ]
[ tag ] [vid ] [cos ] [dscp ] } port-
string
Table 13-1 LLDP Configuration Commands (continued)
Task Command
To Next Page
Loading...
Need help?
General